Sponge for Soldering Iron Stand (50x35mm – 1 PCs)

Description

Sponge for Soldering Iron Stand (50mm – 1 PCs) is a high-quality electronic component designed for Arduino, prototyping, and educational electronics. Product introduction: The soldering iron head shall be heated before each welding, and the “air heating” shall also be conducted at the welding interval, so that the surface of the soldering tin retained on the soldering iron head will have oxide layer. In addition, the residual flux will also become carbon deposit and dirt attached to the surface of the soldering iron head. If they are not removed, they will reduce the electrical contact performance and finish in the welding process, and directly affect the welding quality. In order to ensure the quality of welding, it is necessary to use a cleaning block to wipe these dirt, and then melt the solder. Sprinkle a little water on the cleaning pad during use, and it will swell in case of water. Sponge must be soaked in water, not too much but not too little. Squeeze the excess water, so that the welding nozzle can get good cleaning effect. If the cleaning sponge is not used, the welding tip will be damaged and tin will not be applied. High-quality cleaning sponge for welding is placed on the soldering iron frame and used to clean the soldering tip. It can quickly clean the oxide on the surface of the soldering iron head without damaging the alloy layer of the soldering iron head. Prevent the soldering iron head from oxidation, overheating and burning, remove the solder residue, and